36" CO2 Cylinder Refill Adapter Kit CGA-320 With Gauge for Filling Soda Tank USA

Description

The product has two on/off valves, one is to control the CO2 in the big cylinder into the small cylinder, the other is to release the excess gas after filling.
Easy to install, remember to use a wrench to tighten the connector to avoid leakage.
The product is equipped with a pressure gauge, which can clearly see the gas pressure range, and the pressure is controlled within a safe range.
Please read the instructions before use; the CO2 large tank (gas supply bottle) must have enough pressure, if it is liquid CO2, invert the large tank to inflate.
When the stainless steel braided hose expands, check that the thimble of the vial is not too thick to inflate. If there is, replace the thin thimble bottle and it can be used normally.
Material: Brass
Hose material: stainless steel
Hose Length: 36 inches
Model: with meter
Hose working pressure:
Gauge Pressure: 3000 PSI
Size: CGA-320 (G1/2), cannot be used for paintball
Function: For refilling small CO2 tanks from larger CO2 tanks
H
ow to use:
1. Screw the adapter onto a commercial CO2 cylinder
2. Screw the empty soda gas bottle into the adapter
3. Open the valve of the large cylinder
4. After about 15-20 seconds, the cylinder is completely full
5. Close the valve of the large cylinder
6. Open the exhaust screw to exhaust the remaining gas
7. Check the inflation connector - complete
When using, be sure to pay attention to the following points:
1. The seal is in the correct position. So, when you receive a soda bottle inflation fitting, make sure to use the correct seal on the correct side.
2. Make sure the soda bottle is on the correct side. The CO2 bottle can only be installed on one side of the circle. Therefore, you have to put the soda bottle into the hexagonal one.
Packaging List:
1*36 Inch CO2 Cylinder Refill Adapter